Indeeco Explosion-proof ULTRA-SAFE™ and EP2 duct heaters are Factory Mutual (FM) and cCSAus Approved. The ULTRA-SAFE™ duct heater features the industry’s lowest ignition temperature code rating, T3C, 320°F (160°C). Since there is a high possibility of explosions in areas such as waste water treatment plants , pumping stations and oil and gas sites; heating must…
Here at Indeeco we have Series EP2 Explosion-proof Division 2 Duct Heaters, let’s check them out! Standard Construction Galvanized Sheet Metal Frame includes external duct flanges for field mounting, an element terminal enclosure with control and safety components in an integral cast aluminum explosion-proof box. Three Levels of Safety are provided on every heater: -automatic…
Indeeco has a wide array of custom duct heaters available for all your heating needs. Our heaters and controls range from the simplest standard duct heater to the most sophisticated, custom designed comprehensive system. Indeeco’s attention to detail and rigorous testing give worldwide customers premium products. -Multi-Zone or Dual Duct Heaters: These heaters are designed for…
Indeeco developed the Control Option concept to maintain compliance with changing UL and NEC requirements and to stay current with new electric duct heater temperature control systems. The concept has also been broadened to include numerous “Special Features” to meet a wide variety of special requirements. Internal Wiring Copper wire with a minimum of 105°C…
Indeeco produces WCI Series fan-forced wall heaters that may require KW ratings to be higher and to have a quick recovery. These type of heaters will provide bursts of heat in areas that are affected by cold drafts or where the temperature fluctuates rapidly. Efficient Operation WCI Series wall heater operates by the fan drawing…
Indeeco’s Commercial Sales Manager, Rick Holmes, wrote this article on how to choose a SCR or VERNIER SCR Control. SCR Proportional Control SCR option is normally used when the total heater load is 96 amps or less. Master controller is used for heater loads of 48 amps or less with a Slave controller being added…
The installation of electric duct heaters can take one of two forms – flanged or slip-in mounting. If you are trying to compare and contrast slip-in vs flanged the following article will give you the basics. Existing Ducts For retrofits into existing ducts, flanged mounting like that available on the INDEECO QUZ model is usually preferred. With…
